Solution with
efficiency and cleanness

Gearboxes for single screw extruder

Brief Introduction

NGC’s gearboxes for single screw extruders are designed for the tetra-extruder, the tri-extruder, the dual extruder and the single extruder. These are mainly used in the rubber and plastic industry, and adopted as the device for transmitting power for extruding plastic.
The gearboxes for single screw extruders utilize the parallel cylindrical gears, which are driven by the motor. The screw and the speed ratio of the gear are driven through splines and feeding gear to finish the processes of feeding and extruding.

 

Specifications

XDJ60, XDJ90, XDJ120, XDJ150, XDJ200, XDJ250 and XDJ300.

 

Case

Since the 1990s, NGC has delivered gearboxes to support the manufacturers of main extruders domestically. In 2006, NGC designed  gearbox for tetra-single screw extruders for Guilin Rubber Designing Institute, applied to a Romania factory of Michelin. In 2007, the gearbox for tetra-single screw extruders was applied to a factory in Thailand. 

Sales Network

Sales Hotline
+86 400 186 1110
Email
IGsales@NGCtransmission.com

Service Network

Service Tel
+86 400 829 9900
Email
INservice@NGCtransmission.com